Motorcycle Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
After I started my bike this afternoon, checked the gas, milage, etc. Well two minutes into my ride I had no speedometer, gas guage, neutral light, but my high beam indicator showed it was on? Is this a computer problem? Open to any advice and suggestions.
 

·
Super Duper Mod Man
Joined
·
10,479 Posts
After I started my bike this afternoon, checked the gas, milage, etc. Well two minutes into my ride I had no speedometer, gas guage, neutral light, but my high beam indicator showed it was on? Is this a computer problem? Open to any advice and suggestions.
Try looking at the fuses that are on the circuit. Sounds like blown fuse.
 

·
Registered
Joined
·
11,488 Posts
Try looking at the fuses that are on the circuit. Sounds like blown fuse.
If nothing there; NEXT - check the ground wires on the frame and negative battery terminal.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top