Motorcycle Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Question for anyone. I have owned shaft driven bikes, but want to play with a 5 or 6 speed chain driven engine.
I'm ultimately wanting to find out how not to wreck a reverse kit before I spend money on the thing. The question is,... if I am turning 5,000 RPM on anyone particular engine, then what is the actual RPM on the drive shaft? I realize the spocket differential, tire size, but not real sure on the shaft RPM from 1st to 5th,
6th or how to figure it out without putting,.....say a RPM gun on the thing for an actual reading? I feel like I have a brain fart here since I'm turning a sled into a 4wheeler and have that figured out. Thanks, Battleaxe
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #5 ·
Thanks guys, I didn't even think I had a response to this........Sorry where I asked the question, and the reason why is cause I'm putting a cycle engine into a singe seat buggy but want reverse in it. I'm re-routing the shifter to a linkage to take the spot just as a manual shifting truck or car would have, it just won't be a pattern, but rather a shift forward or back. It will have two brake pedals also, one to lock up just the rear, and another to lock up all four. Again just for the fun of it, where I have to ride it, etc....Reverse is pratical when being strapped in a little buggy, and I do want the power, reliability , and the fun shifting that a bike engine offers. That's what I'm up to. Thanks again.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top