Motorcycle Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
540 Posts
Not one's being much help here, but a better forum to ask would be the Magna forum, where they're pretty passionate about the bike. But...whether it's 200 degrees or 800 degrees you're probably best off using the highest temp sealant available to you. The combination of heat and pressure will be hard on it anyway. Could a good welder solve your problem?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top