Motorcycle Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11,482 Posts
Midrange carburetion is controlled by the needle. Adjusting the idle screws won't change midrange leanness.

All you have to do is remove the fuel tank and you can remove the carb tops, remove the needles, place 1/8" thick plastic washers in the needle seats and replace the needles.

You can see if there's a Holeshot jet kit. But the washer fix is really quick and simple and might just do the trick.
Hory Clap! 1/8" Washers! (0.125")

More like 0.030" (vaguely 1/32" or ~0.8mm) to 0.035" thick washers, MAX I'd say.

Try a #6 or #8 washer, if you can't find metric that'll fit..............
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top