Motorcycle Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
10,903 Posts
Discussion Starter · #3 ·
I would rather have one of those than a chopper. Odd choice of bike to throw that much money into it.

I wouldn't pay 7 grand for it, though.
Well that's cuz living in a PA farmhouse, no one would ever see it.

I could bling up and down the coast all day on this. Of course then I'd have to spend a week polishing all the salt air goop off of it.
 

·
Registered
Joined
·
4,129 Posts
There's a CBX parts specialist in GA that you can source parts from if you do it. The shop is called Tim's International and the guy that owns it is Bill Brent. I've known Bill for about a decade. If the part can't be found he can fabricate it. Some of the restorations I seen from him are truly rolling art.
 

·
Registered
Joined
·
10,903 Posts
Discussion Starter · #7 ·
There's a CBX parts specialist in GA that you can source parts from if you do it. The shop is called Tim's International and the guy that owns it is Bill Brent. I've known Bill for about a decade. If the part can't be found he can fabricate it. Some of the restorations I seen from him are truly rolling art.
I've check out their website. They want some serious cash for that rolling art!
 

·
Registered
Joined
·
4,129 Posts
I've check out their website. They want some serious cash for that rolling art!
Bill don't play! There's a guy in the Northeast that may be as good, but in the country I doubt there are 4 or 5 guys total that meet the expectations of what you should get for your money.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top