Help! ZX-9 Carbs on a Mazda Rotary.
1 - 6 of 6 Posts
Joined
·
3,875 Posts
You need to place the vac***** port at the point of maximum vacuum. This would probably be point of greatest restriction, between the carbs and the engine.
www.rx7club.com is a good resource for these questions.
www.rx7club.com is a good resource for these questions.
Below the venturi and above the throttle blade, or at least the position where the throttle blade closes at idle.
In a pinch, it is possible to run the distributor off manifold vacuum. Not optimal, but it'll work.
Or you could just leave off the vacuum advance altogheter, particularly if this is a race motor.
In a pinch, it is possible to run the distributor off manifold vacuum. Not optimal, but it'll work.
Or you could just leave off the vacuum advance altogheter, particularly if this is a race motor.
Joined
·
1,521 Posts
What is vac*****? You are not into filth again pplassm?
- cruiz-euro
- cruiz-euro
1 - 6 of 6 Posts
Join the discussion
