Motorcycle Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
So on my '75 CB 360, it runs really good. It starts right up and i can ride it anywhere. . .but it won't idle. When i turn up the idle screw, it idle's fine at about 1100RPM. . .but then when i rev ithe throttle up to about 3000RPM it just stays there and i have to turn the idle screw back down to where it won't idle. It can't be an air leak because it would just do that all the time right? But it only does it when the idle screw is turned up. And i don't understand how it could be a mechanical issue because the idle screw is one, stationary, seperate screw that really doesn't interfere with a lot of things other than moving the throttle linkage up and down. I mean i know it has to be one of the two, but it just seems like this thing is braking laws of physics or something! ha ha, or maybe i'm just dumb, but if anyone has any ideas, PLEEEEAAAAAASE let me know! Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top