Motorcycle Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
7,113 Posts
I had a bike that if the clutch was set up too tight, the lever that actuated it would give instead of pushing as it should.

Any chance you didn't stack the stell and fiber plates correctly? One too few perhaps?

Is your clutch hydralic or cable? Is it possible to watch the clutch action while you pull the lever in? Either one can be out of adjustment enough to keep the clutch from actuating fully.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top