Motorcycle Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
7,113 Posts
Ten whole minutes? Not likely

That would actually be 10 seconds to come up with the idea. 10 months for the idea to get transmitted from the CEO through all the VPs, Asst Vps, marketing specialists, corporate lawyers, safety and environmental departments, design engineers and finally to the old guy in the back room in the basement who just happens to be the only actual working production employee left in the company. Then there's 5 years for all the permits needed from the EPA, DOT, HUD, HEW, DOD, FBI, EPA again, PETA, your Uncle Ted.......
And of course it must ultimately be approved at:

The Court of the CRIMSON KING!!!!!

Man, what a flash from the past that one is...good times, gooood times.
 

·
Registered
Joined
·
7,113 Posts
I have one preinstalled from the factory of G.O.D. Enterprises. I believe its called "The Left Index Finger." It has millions of other uses and is handy on hard to reach boogers that form after riding in the rain for hours.
The gloves I never wear have a squeegee on them. But you have to wear a helmet too for that to do any good.
 

·
Registered
Joined
·
7,113 Posts
I play the record on the turntable and use patchcords from the aux_out to the mike input on my soundcard. I use Wavepad software to save the music as a wav file. Wavepad will do click/pop suppression on the sound and save the files in mp3 format as well as wav. It works pretty good. You just have to remember that those analog recordings need equalization processing because the digital players of today don't have the treble and bass controls we used to use to make the vinyls sound good. There is a sound processing suite that came with my motherboard's built in sound card that does that.
What about the part where the mouse eats the cheese and that makes the marble roll down the drain pipe which causes the guy to hop off the diving board and....
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top